Removing the Hotpoint Electric Range Manual

Are you struggling to remove your old Hotpoint electric range manual? If so, this article is here to help guide you through the process.

For more specific help and instructions, I suggest calling The GE Answer Center at 1-800 or hiring a professional installer experienced with this older style Microwave Hood. Unfortunately, the GE website does not provide detailed installation instructions, and the owner's manual only covers general information.

To remove the Hotpoint electric range manual, you will need to follow these steps:

Step 1: Unplug AC Power

Unplug the power cord from the unit or turn off the circuit breaker to ensure your safety while working on the appliance.

Step 2: Remove Top Grill

Remove the top plastic grill over the door and control panel by unscrewing the two screws that hold it in place.

Step 3: Release Microwave Sub-Assembly

Next, remove the larger left and right screws holding the microwave sub-assembly in place. This will allow you to access the rear mounting screw holes.

Step 4: Drop Down Light Bulb/Air Filter Cover Panel

Drop down the hinged light bulb/air filter cover panel by unscrewing the seven screws that hold it in place.

Step 5: Remove Small Metal Cover Plate

Remove the small metal cover plate on the right under the control panel to access the rear mounting screw holes.

Step 6: Disconnect Microwave Sub-Assembly Connector

Disconnect the microwave sub-assembly connector from the electrical system.

Step 7: Remove Rear Mounting Screws

Carefully remove the rear mounting screws, taking note of their location and type. You may need to fish the power cord through the cabinet or unscrew the power cord terminals to access these screws.

Step 8: Remove Microwave Sub-Assembly

Pull the microwave sub-assembly out of the frame and set it aside.

Please be aware that this process is quite involved, and it's recommended to have a helper assist you due to the weight of the sub-assembly (approximately 25-30 pounds).

Based on my recent experience removing an old Hotpoint RVM58003 Microwave Hood from 1984, it appears that the unit was originally installed in this manner. The rear mounting screw holes are part of the outer frame of the unit, which requires removal of the microwave sub-assembly to expose the outer metal frame and pre-drilled rear mounting holes.

In conclusion, removing an old Hotpoint electric range manual can be a challenging process, but by following these steps, you should be able to successfully remove it. If you're unsure or uncomfortable with any part of the process, consider calling a professional for assistance.